Install the rear top cross connection
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in and position the rear top (3) cross connection.
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Rear cross connection at the top of the hood lock support | ||
| Hexagon screw M6x20 |
Tightening torque | 8 Nm |
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear top cross connection to wheel arch carrier support | ||
| M10x50 screw Replace screw. |
Snug torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .