Removing intake silencer housing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Unlock plug connection (1) and disconnect.
- Unfasten clamp (2).
- Remove screws (arrows).
- Remove the upper section of the intake filter housing (3).
- Remove the air filter element (1).
- Loosen screw (1).
- If installed: Unlock and loosen the clamps (2).
- Pull the intake silencer housing lower part (3) up and out of the rubber mount and remove it.