Install control unit bracket
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the control unit bracket (1) at bottom is fed into the mount (2) correctly.
- Insert and install the control unit holder (2) in the direction of the arrow.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Control unit bracket at the shock tower | ||
| Hexagon screw | tightening torque | 8 Nm |
- Mount the cable bracket (1) together with the wiring harnesses and lock it audibly.
- Secure the wiring harness in holder (1).
- Secure the holder (1) audibly.
- Secure the cable with the clamp (2) on the control unit holder.
- Pin up connector (3) and lock audibly.
- Secure the connector (3) on the control unit holder.
Follow-up work
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to ACTIVATING ELECTRICAL SYSTEM .