Removing starter motor
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to DEACTIVATING ELECTRICAL SYSTEM .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
Precondition
Battery ground leads are disconnected.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Working on 12V electrical system.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
NOTE:
TECHNICAL INFORMATION
When removing the starter, ensure that the lower acoustic cover is not damaged.
A damaged lower acoustic cover can only be replaced when the front axle is lowered.
When removing the starter, ensure that the lower acoustic cover is not damaged.
A damaged lower acoustic cover can only be replaced when the front axle is lowered.
- Release the nut (1) and remove the positive battery cable from the starter.
- Release the nut (2) and remove the cable (terminal 50) from the starter.
- Remove the cable (1) (terminal 50) from the starter.
- Loosen the clamp (2) and place the cable aside.
- Remove positive battery cable (3) from starter motor.
- Disconnect the positive battery cable from the clamp and place it aside.
- Remove the expanding rivet (4) from the acoustic cover at the rear.
- Loosen clip (5).
- Remove the expanding rivet (1) from the acoustic cover at the front.
- Remove the expanding rivet (1) in the center of the acoustic cover.
- Make sure that the acoustic cover (1) is not damaged.
- Carefully press the acoustic cover (1) to the side.
- Loosen screws (2).
- Carefully guide the starter (3) out in the direction of the arrow and remove.