Installing the ignition coils

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Damage to the ignition coil.
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil.

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Insert and install the ignition coil (3).
Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATIONS

Ignition coil to cylinder head cover
Screw M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock the connector (1).
The connector (1) must engage audibly.

Follow-up work

Refer to INSTALLING THE SERVICE OPENING IN SOUND INSULATION ON TOP OF ENGINE .
Refer to INSTALLING ACOUSTIC COVER .