Installing the heat shield on the cylinder head
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Thread in the heat shield (2) and position.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Heat shield to cylinder head | ||
|---|---|---|
| M8x12 | Tightening torque | 19 Nm |
- Version without Real Driving Emissions 2 (-SA1DZ):
Feed the heat shield (2) into the marked area and install it.
Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Heat shield to cylinder head | ||
|---|---|---|
| M8x12 | Tightening torque | 19 Nm |
- Version without Real Driving Emissions 2 (-SA1DZ):
Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Heat shield to trim strip | ||
|---|---|---|
| M6x12 | Tightening torque | 8 Nm |