install the cover panel for the front axle left and right

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform the steps on the right and left side.

Remove the cover of the steering assembly

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Release all bolts (arrows).
Remove cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the front wheel arch trim

Loosen blind rivet (1).
Unclip the wheel arch trim (2) from the detents (3) on the bumper and on the trim panel of the side member.

Courtesy of BMW OF NORTH AMERICA, INC.
Unclip and remove the wheel arch trim (1) from the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Remove the rear section of the front wheel arch cover front

Remove screws (arrows).
Guide out rear section (1) of wheel arch cover at front and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Removing the front lower wheel arch cover

Release all bolts (arrows).
Guide the wheel arch cover (1) out.

Courtesy of BMW OF NORTH AMERICA, INC.