Removing the front output shafts (on the mobile lifting table)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

Remove the sealing cap (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).
Remove the swivel bearing mount (2) and set it aside.
Hold the swivel bearing (3) with the workshop crane 2 220 718.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1).
Tilt the swivel bearing (2) slightly forward in the arrow direction.
Loosen and remove the output shaft (3) at the front axle differential with a suitable tool.

Courtesy of BMW OF NORTH AMERICA, INC.
Install the stand (1) of the swivel bearing.
Tighten down screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.