Releasing and removing front axle support

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

Disassemble the front axle support

WARNING: Heavy component falling down or tipping.
Danger! Immobilization period-threatening injuries!

Before lowering or removing the front axle: Securing engine to the installation position.
For additional information see: MOVING THE ENGINE TO THE INSTALLATION POSITION .

Partially releasing left and right crash levers

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

NOTE: Perform the steps on the right and left side.

Release nut (1).
Remove the bolt (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Releasing the adapter for the front axle support from the front axle support on the right and left

NOTE: Perform the steps on the right and left side.

Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1) to (3).

Fig 1: Front Axle Support Screws Loosening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Completely removing the front axle support

Carefully lower and remove the front axle support with the universal jack 0 490 133 (00 2 030) .

Courtesy of BMW OF NORTH AMERICA, INC.