Installing the special tool on the cylinder head
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Prepare special tool 2 459 012
.
- Unlock the locks (arrows).
- Feed out the wiring harness section (1) for sensor system 2 and place to one side.
- Thread in special tool 2 459 012 and position.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Special tool to cylinder head | ||
|---|---|---|
| M8 | Tightening torque | 21.5 Nm |