Fasten electric coolant pump and coolant hoses to the front axle support
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
- Fasten holder (1) to the right hand side of the front axle support (2).
- Fasten coolant hose (1) on the brackets (2) on the front axle support.
- Position the holder for the electric coolant pump (2) on the front axle support (2).
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Holder to front axle support | ||
|---|---|---|
| M6 Replace screw. |
Tightening torque | 8 Nm |
- Secure coolant hose (1) on the holders (2) at the front subframe.NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
- Position the holder for the electric coolant pump (2) on the front subframe (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Holder to front axle support | ||
|---|---|---|
| M6 Replace screw. |
Tightening torque | 8 Nm |