Attach the right and left tension struts on the swivel bearing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Securing tension strut on swivel bearing
- Make sure there is sufficient distance (1) between the wheel speed sensor (2) and the output shaft (3).
- Turn swivel bearing (4) outwards.
- Place the output shaft (3) in the driving direction to the side.
- Position tension strut (2) on swivel bearing (3).
- Replace nut (1).
Parts: Nut
- Tighten nut (1).NOTE: Counter-hold at the Torx socket.
TIGHTENING TORQUES SPECIFICATION
| Tension strut to swivel bearing | ||
|---|---|---|
| M16 Replace nut. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |