Remove drive belt
Preliminary work
- Refer to REMOVING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to REMOVING BOTH FRONT-END STRUTS .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING FAN COWL .
- Refer to PARTIALLY RELEASING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
CAUTION:
Spring preload.
Injury hazard!
Injury hazard!
- The use of the specified special tool (tool) is mandatory.
- Carry out the described steps properly.
- Release the belt tensioner (2) clockwise with a suitable socket wrench (1).
- Maintain the preload of the belt tensioner (1) using a suitable socket wrench (3).
- Secure the belt tensioner (1) against turning with the special tool 0 496 268 (11 0 390)
(2).
- Remove belt (1).