When replacing the left-hand turbocharger: Remount components
- Unscrew the banjo bolt (1)
.
- Feed out and remove the coolant pipe (1)
from the pin (arrowed).
- Unscrew the banjo bolt (1) .
- Loosen screw (2) .
- Remove the coolant pipe (3)
.
- Replace the banjo bolt.
Parts: Hollow bolt
- Replace seals (1)
.
Parts: Seals
- Replace the right turbocharger.
Parts: Right turbocharger
- Position the coolant pipe (3) .
- Position the banjo bolt (1) and screw in several threads.
- Hand-tighten the bolt (2) .
- Tighten the banjo bolt (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Banjo bolt for coolant pipe to turbocharger | ||
|---|---|---|
| Hollow bolt | Replace the banjo bolt. Joining torque |
8 Nm |
| Angle of rotation | 60° | |
- Tighten down screw (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant line to turbocharger | ||
|---|---|---|
| M6x16 | tightening torque | 10 Nm |
- Replace the banjo bolt.
Parts: Hollow bolt
- Replace seals (1)
.
Parts: Seals
- Feed in and position the coolant pipe (1)
on the pin (arrowed).
- Tighten the banjo bolt (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Banjo bolt for coolant pipe to turbocharger | ||
|---|---|---|
| Hollow bolt | Replace the banjo bolt. Joining torque |
8 Nm |
| Angle of rotation | 60° | |