Installing the control arm
- Position the control arm (2) .
- Replace the screw (1)
.
Parts: Screw
NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION . - Screw in the screw (1)
but do not yet tighten.
- Replace screw (1)
and nut (2)
.
Parts: Bolt, nut
- Insert the screw (1)
.NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION . - Unscrew the nut (2)
but do not yet tighten.
- While installing the cable bracket (1)
, make sure that the pin on the cable bracket (1)
fits in the hole of the control link (2)
.
- Install the cable clip (2) .
- Secure the cable (1)
to the cable clip (2)
.