Removing The Tail Panel

NOTE: Perform the steps on the left and right side.

Carry out rough cuts (1) and (2) immediately below the rear light holder (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Open welded connections in area (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Continue rough cut (1) coming from the outer side to the inside in accordance with the illustration.
Carry out rough cut (2) in accordance with the illustration and remove the tail panel.
Release welded connections in areas (3) and remove section (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Release the welded connections in the area (1) and remove the section (2).

Courtesy of BMW OF NORTH AMERICA, INC.