Install Tail Panel Outer Section
NOTE:
Perform the steps on the left and right side.
- Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surfaces on vehicle and on new part with cleaning agent R1.CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K5 to the bonding surfaces.ADHESIVE SPECIFICATION
Body adhesive K5 195 ml 83195A59935 - Install new part.
- Rivet new part in the areas (1) to (3) with blind rivets N3.CONSUMABLE SPECIFICATION
Blind rivet N3 83190301421 Ø 4 mm; clamping area 1-3 mm - Rivet the tail cowling in the areas (1) and (2) with punch rivets N4 and N5.
Area Number Punch rivet 1 16 N4 2 11 N5 CONSUMABLE SPECIFICATIONPunch rivet N4 83192457307 Ø 3 mm; 4 mm long CONSUMABLE SPECIFICATIONPunch rivet N5 83192158079 Ø 5 mm; 5 mm long Installing the EMC screw
- Drill a hole with a diameter of 4.2 mm.
In the case of glued connections, only drill the hole after the adhesive has fully hardened.
- Screw in the EMC screw
.CONSUMABLE SPECIFICATION
EMC screw SF Plus M5x15 83190301639 - Seal the EMC screw
with the sealant.CONSUMABLE SPECIFICATION
Sealant D1 (seam sealing) 310 ml 83422409985 NOTE: TECHNICAL INFORMATION
Avoid contact of the escaped adhesive with the support for the bumper cover. Do not use any cleaning agents containing solvents. - Press in the tail cowling in area (1) and remove the emerging adhesive.
- Attach the support for bumper cover.
- After the adhesive has hardened install 3 EMC screws in the areas (2) (3).CONSUMABLE SPECIFICATION
screw 83190301639 EMC screw, SF Plus, M5x15