Removing The Outer Section Of The A-Pillar

Release welded connections in areas (1).
Release the brazed connection in area (2).
NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Releasing bonded connections
Open spot-welded adhesive joints in areas (3).
NOTE:
RISK OF DAMAGE
Damage to bonded connection .
Influence of heat that is too large leads to damage on bonded connections lying on the beading or below .
- Warm bonded connection only for a short time, maximum up to 120°C.
Courtesy of BMW OF NORTH AMERICA, INC.
Do not damage the bonded connections in the areas (4) between the panels located underneath!
Release bonded connection in area (5).
Release the outer section of the A-pillar from the cavity sealing (6) and remove.