Installing The Rear Outer Wheel Arch Section
NOTE:
TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
When installing the new part, make sure that all bonding surfaces have sufficient adhesive.
- Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surfaces on vehicle and on new part with cleaning agent R1.CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K5 to bonding surfaces.ADHESIVE SPECIFICATION
Body adhesive K5 50 ml 83192158654 - Install new part.
- Rivet new part in the areas (1) to (3) with blind rivets N3.CONSUMABLE SPECIFICATION
Blind rivet N3
'0 4 mm; clamping area 1-3 mm83190301421 NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of a cavity sealing (not expanding) - Apply sealant D1 to the new cavity sealings (1). Fit cavity sealings (1).CONSUMABLE SPECIFICATION
Sealant D1 (seam sealing) 310ml 83422409985