Remove The Outer Wheel Arch Section With The Reinforcement

Carry out the separating cut (1) as shown. Disconnect only the outer panel.
Remove the outer cavity sealing (2).
Loosen welded connections in areas (3).
Remove the support of the C-pillar along with the inner cavity sealing (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen welded connections in areas (1).
Remove the reinforcement on the C-pillar.

Courtesy of BMW OF NORTH AMERICA, INC.
Mark separating cut (1) according to dimension (a) and make the cut.
Dimension (a) = 20 mm
Loosen welded connections in areas (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Continue with the separating cut (1) from the previous step to the dimension a.
Dimension a = 20 mm.
Release the welded connections in the area (2) and remove the outer wheel arch section.

Courtesy of BMW OF NORTH AMERICA, INC.