Installing the front wheel speed sensor
- Clean bore for wheel RPM sensor and grease using lubricating grease (see applicable BMW parts catalogue).
CONSUMABLE SPECIFICATION
| Lubricating grease Staburags NBU 12K | 100 g, Tube | 83 23 9 407 810 |
- Install rear wheel speed sensor.
- Position and tighten the screw (2).
TIGHTENING TORQUES SPECIFICATION
| Front wheel speed sensor on swivel bearing | ||
|---|---|---|
| Screw Replace screw. |
Tightening torque | 12 Nm |
- Connect the cable of the wheel RPM sensor in the holders (1).
- Connect the cable of the wheel RPM sensor in the holders (1).
- Connect plug connection and close housing cover (2).
Follow-up work
- Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .