Install front brake hose
- Attach brake hose to the holder (1).
Observe installation sequence:
- Secure brake hose in the holders.
- Move wheels into straight-ahead position.
- Screw brake hose onto the connection between pipe and brake hose.
- Screw brake hose on brake caliper.
- Position and tighten the union screw (2). If necessary, use the square end (3) for counter support.
TIGHTENING TORQUES SPECIFICATION
| Brake pipe screw connection/Union screws | |
|---|---|
| tightening torque | 17 Nm |
- Position and tighten the brake hose (1) on the brake caliper and use the knurling (2) for counter support as needed.
TIGHTENING TORQUES SPECIFICATION
| Brake hose to brake caliper, front | |
|---|---|
| tightening torque | 17 Nm |
- Attach brake hose to the holder (3).
Follow-up work
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING FRONT BRAKES (AFTER PART EXCHANGE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .