Flush the rear brake and air bleed
NOTE:
Description is for right component only. The procedure on the left side is identical.
- Work through the instructions in the service function in sequence.
- Begin with the flushing at the right rear.
- Connect the vent hose with the collecting vessel to the bleed valve (1) on rear right brake caliper.
- Open the bleed valve (1) and purge it until clear, bubble-free brake fluid emerges.
- Close bleed valve.
TIGHTENING TORQUES SPECIFICATION
| Rear bleed valve | ||
|---|---|---|
| Bleed valve | tightening torque | 10 Nm |
- Carry out the same procedure on the rear left wheel brake.