Brake test on the front axle on the brake test stand (all-wheel drive)
NOTE:
TECHNICAL INFORMATION
Only brake dynamometers may be used with a testing speed between 3 km/h and 6 km/h.
Only brake dynamometers may be used with a testing speed between 3 km/h and 6 km/h.
Preliminary work
- Refer to PREPARING THE BRAKE TEST .
- Drive the front wheels of the vehicle onto the brake test stand.
- Position the selector lever in selector lever position (N) (neutral).
- Run engine at idle speed.
The brake test stand starts automatically.
- Press brake pedal.
- Read the maximum brake forces on the left and right.