5413 Convertible Top
| Crash plate on B-pillar | ||
| Screw | Tightening torque | 8 Nm |
| Crash plate on roller blind cover | ||
| Screw | Tightening torque | 10 Nm |
| Guide rail on bodyshell | ||
| Nut | Joining torque | 1.5 Nm |
| Angle of rotation | 120° | |
| Guide rail on bodyshell | ||
| Screw | Tightening torque | 10 Nm |
| Guide sleeve on mechanics | ||
| Screw | Tightening torque | 4 Nm |
| Panorama glass roof lid to mechanics | ||
| Screw | Tightening torque | 6 Nm |
| Roller module on guide rails | ||
| Hexagon screw | Tightening torque | 1.6 Nm |
| Roller module on roof module | ||
| Hexagon screw | Tightening torque | 4 Nm |
| Roller sunblinds on roller blind cover | ||
| Screw | Tightening torque | 3.5 Nm |
| Linkage aperture flap to connecting bracket | ||
| Sheet metal screw 4.8x19 Replace screw. |
Tightening torque | 2.6 Nm |
| Base plate to window frame | ||
| Screw Replace screws |
Tightening torque | 8 Nm |
| Convertible top compartment lid mechanism on bodyshell | ||
| Screw | Tightening torque | 19 Nm |
| Convertible top latch to front strut | ||
| Nut Apply Loctite. |
Tightening torque | 15 Nm |
| Convertible top main bearing to bodyshell | ||
| Hexagon nut | Tightening torque | 19 Nm |
| Front strut to convertible top linkage | ||
| Screw | Tightening torque | 35 Nm |
| Locking plate to hydraulic unit | ||
| Screw | Tightening torque | 6 Nm |
| Rear window to convertible top linkage | ||
| Screw | Tightening torque | 4.2 Nm |
| Seal carrier to convertible top | ||
| Screw | Tightening torque | 11 Nm |
| Tension cable to convertible top linkage | ||
| Screw | Tightening torque | 11 Nm |
| Windshield panel Gasket to front strut | ||
| Screw | Tightening torque | 1.8 Nm |
| Windshield panel trim to front convertible top | ||
| Screw | Tightening torque | 2 Nm |
| Windshield panel trim to side convertible top | ||
| Screw | Tightening torque | 3 Nm |
| Convertible top compartment to bodyshell | ||
| Screw | Tightening torque | 4.5 Nm |