Install upper cross connection
- Position upper cross connection (2) with holders (4).
- Tighten down screws (3).TIGHTENING TORQUES SPECIFICATION
Top cross connection to rear top cross-connection Combination clamping screw with ISA Tightening torque 8 Nm - Attach Bowden cable (1) in the upper cross connection (2).
- Guide in support (2) of the upper air flap control and position.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Support for top air flap control at the top of the lock | ||
|---|---|---|
| Combination clamping screw with ISA | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .