Installing underbody protection at rear
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Version 1:
Feed in rear underbody protection (1) and install.
Tighten the screws (arrows).
TIGHTENING TORQUES SPECIFICATIONUndershield screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm - Version 2:
Guide in underbody protection (1) and position it correctly.
Tighten the screws (arrows).
TIGHTENING TORQUES SPECIFICATIONUndershield screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm - Version 3:
Insert the rear underbody protection (1).
Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Undershield | ||
|---|---|---|
| screw | Tightening torque | 2.6 Nm |
| Plastic nut | Tightening torque | 2.6 Nm |