Replacing the windshield rubber frame
- Detach the windshield rubber frame (1).
- Clean the adhesive area of the windshield rubber frame (1).CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Replace the windshield rubber frame (1).
Parts: Rubber frame
NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details. - Insert the cover (1) in the guides (3) of the special tool 0 496 529 (51 3 320) .
- Detach protective film (2) in stages from adhesive tape.
- Position the windshield rubber frame (1) in the center on the mark (2).NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Place the special tool 0 496 529 (51 3 320) with the pressure rollers (1) on the window edge.
- Align cover at outer edge of windshield.
- Put the cover on and visually check to make sure it is positioned correctly.NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Reposition the lever (1) in arrow direction and close the special tool 0 496 529 (51 3 320) .
- Make sure the cover (3) is positioned correctly in the guide pulleys (2).NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.
- Continue to detach protective film (1) in stages from adhesive tape.
- Pull the special tool 0 496 529 (51 3 320)
in arrow direction with the handwheel over the entire upper edge of the window glass and roll up the rubber frame in the upper area.
- Roll up the windshield rubber frame (1) in the upper area with the special tool 0 496 529 (51 3 320)
.NOTE: Perform the steps on the right and left side.
- Position the windshield rubber frame (1) sideways on the marks (2) and press it manually.
- Correctly position the windshield rubber frames (1) on the side.
- Pull out the liner (2) on the windshield rubber frame (1) and press over the entire length manually.