Install the seat belt finisher strip

Feed the seat belt (2) into the seat belt finisher strip (1).
Clip the clip (3) into the seat belt finisher strip (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Position the seat belt finisher strip (2) on the rear side trim panel and clip it into the detent (3).
Replace the screw (1).
Part: Screw
Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Seat belt finisher strip to angle bracket
Sheet metal screw 4.8x19 Replace screw.	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.