Installing hood lock

• Hook the cable linkage (3) into the hood lock (2).
• Feed in the hood lock (2).
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hood lock
  Flat-head screw M6x20	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure cable with the clips (2) to the hood lock.
• Connect connectors (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Activating the 48 V electrical system 

Precondition 

Ignition is switched off.

• Raise the battery ground cable (1).
• Remove special tool 2 452 007  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release the negative battery cable (2) of the 48-V battery from the attachment.
• Position the negative battery cable (2) of the 48-V battery on the negative battery terminal.
• Tighten the nut (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Negative battery cable to 48-V battery
  Nut M8	tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (1) of the CAN bus and lock it.
• Clip in the clip (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Activate the 48 V electrical system by closing the hood.

  The activation takes place automatically.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .