Adjust lock striker
NOTE:
Description is for left component only. Procedure on the right side is identical.
Precondition
The screws on lock striker are loosened so far that the lock striker can still be shifted.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see:
GAP DIMENSIONS FOR BODY .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see:
GAP DIMENSIONS FOR BODY .
- Adjust the height of the lock striker so that the door lock does not bump or drag.
- Shift the lock striker sideways to adjust the gap dimension (protrusion) of the door.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lock striker | ||
|---|---|---|
| screw | Tightening torque | 21 Nm |