Adjust lock striker
Precondition
The screws on lock striker are loosened so far that the lock striker can still be shifted.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see:
GAP DIMENSIONS FOR BODY .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see:
GAP DIMENSIONS FOR BODY .
- Adjust the height of the lock striker so that the door lock does not bump or drag.
- Shift the lock striker sideways to adjust the gap dimension (protrusion) of the door.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lock striker | ||
|---|---|---|
| screw | Tightening torque | 21 Nm |