Install rear bumper panel
- Position the rear bumper cover (1) with the help of a support person.
- Connect connectors (2) and lock.
NOTE:
Perform the steps on the right and left side.
- Clip the rear bumper cover into the detents (1).
- Clip the rear bumper cover into the detents (1).
- Secure expanding rivet (2).
- Fasten the license plate on the rear bumper cover.
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Bumper cover to guide, middle | ||
|---|---|---|
| Oval-head screw for thermoplastic | tightening torque | 3 Nm |
NOTE:
Perform the steps on the right and left side.
- Fold back the wheel arch cover (1).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Rear mount to bumper cover | ||
|---|---|---|
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
NOTE:
To provide a better overview: Schematic diagram without rear wheel.
NOTE:
Perform the steps on the right and left side.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Rear wheel arch cover to body | ||
|---|---|---|
| Plastic nut with flange | Tightening torque | 2 Nm |
- Tighten screws (2).
TIGHTENING TORQUES SPECIFICATION
| Rear wheel arch cover to rear bumper cover | ||
|---|---|---|
| Plastic hexagon screw | Tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALLING BOTH EXHAUST COVERS .
- Refer to INSTALLING THE REAR BUMPER TRIM .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANELS .
- Refer to INSTALLING COVER FOR WATER CHANNEL ON LEFT AND RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL LEFT AND RIGHT PARTIALLY .
- Refer to INSTALLING THE TOP LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING TRUNK COMPARTMENT LIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .