Replace Trunk Lid
Remounting the install parts of the trunk lid
- Remount the clips (1).NOTE: Perform the steps on the right and left side.
- Push through the pins (1) of the stop pad (2) and remove the stop pad (2).
- Mount the stop pad (2) to the new trunk lid.
- Drive in the pins (1) of the stop pad (2) until they are flush.
Install the gutter strip for the trunk lid
- Center the gutter strip for the trunk lid (1).
- Use the centered gutter strip for the trunk lid (1) to mark the start of the adhesive bond on the outside of the trunk lid (2).
- Fit the gutter strip for the trunk lid (1) at the mark for the start on the trunk lid (2) as shown.
- Route the center part of the gutter strip for the trunk lid (1) parallel to the edge (3) of the trunk lid (2) and fix temporarily with adhesive tape.
- Gradually pull off the protective film for the gutter strip (1).
- Check the position of the gutter strip for the trunk lid (1) and correct where required.
- Adhesive bond the gutter strip for the trunk lid (1) without overstretching or compression along the edge (3) of the trunk lid (2).
- Always press on the gutter strip for the trunk lid (1) perpendicular to the bonding surface.