Install wheel well connection
NOTE:
Perform the steps on the left and right side.
NOTE:
TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
- Clean the bumper cover (1) in area (2).
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | |
|---|---|
| Cleaning agent R2 | 2 min |
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
NOTE:
TECHNICAL INFORMATION
Bonding at room and object temperature of >+18°C
Bonding at room and object temperature of >+18°C
- Detach the protective film from the wheel well connection (1).
- Position the wheel well connection (1) centrally between the marking lines (2).
- Firmly apply thumb pressure to the wheel well connection (1) over the entire adhesive area.
Prepare bonding with adhesive K6
NOTE:
TECHNICAL INFORMATION
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
Bonding surfaces must be dry and free of dust and grease. After the adhesive area has been cleaned, it must no longer be taped with bare hands.
- Clean adhesive area and allow to dry.
TECHNICAL DATA SPECIFICATION
| Air drying time after cleaning | |
|---|---|
| Cleaning agent R2 | 2 min |
CONSUMABLE SPECIFICATION
| Cleaning agent R2 | 500 ml | 83190417324 |
- Brush adhesive area with primer and allow to dry.
TECHNICAL DATA SPECIFICATION
| Air drying time after the order | |
|---|---|
| Loctite SF 770 | 30 s |
- Apply adhesive all over.
ADHESIVE SPECIFICATION
| Adhesive set K6 | 11 g, Loctite 3090 | 83195A547C4 |
| 10 g, Loctite SF 770 | ||
| 2, Mixing tube |
- Fix the wheel well connection all over with adhesive.
ADHESIVE SPECIFICATION
| Adhesive set K6 | 11 g, Loctite 3090 | 83195A547C4 |
| 10 g, Loctite SF 770 | ||
| 2, Mixing tube |