Installing starter motor

• Insert and install the starter motor (2).
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Starter motor to crankcase
  M8x60	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Thread in and position the acoustic cover (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure all expanding rivets (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1).
• Make sure the connector (1) engages audibly.
• Insert and install the positive battery cable (3).
• Secure positive battery cable (3) at the clamp (4).
• Tighten the nut (2) hand-tight.

  Courtesy of BMW OF NORTH AMERICA, INC.

  CAUTION: Improper routing of the positive battery cable. 
  Risk of short circuits! 

  • Route the positive battery cable without abrasions and do not trap.
• Correctly  attach the positive battery cable (1) to the anti-twist lock (2).
• Tighten nut (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .