Removing the front roof frame trim

Preliminary work

NOTE: The operations shown only for one side must be carried out on both sides.

Slide forward and remove the clamp (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Mark the separation line around parallel to the external edge.
Dimension a=20 mm

Dimension b = 10 mm left and right

Dimension c = 10 mm

Courtesy of BMW OF NORTH AMERICA, INC.
Install depth stop (1) and saw blade (2) on the oscillating saw.
Use special tool 5 A0B 392 and 5 A0B 426 .
Adjust depth stop (1) to 4 mm.
Separate front roof frame trim all around the marking.
Remove the separated part.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Wear safety goggles.

Disconnect adhesive bead (1) around with oscillating knife (2).
Use special tool 5 A0B 3B6 .
Remove roof frame trim.

Courtesy of BMW OF NORTH AMERICA, INC.