Installing the heat shield on the exhaust manifold
- Position the heat shield (4) .
- Tighten down screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to cylinder head M8 x 12 Tightening torque 19 Nm - Attach heat shield (2) in marked area.
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to cylinder head M8 x 12 Tightening torque 19 Nm - Tighten the bolt (1)
on the heat shield (2)
.TIGHTENING TORQUE SPECIFICATIONS
Heat shield to trim strip M6 x 12 Tightening torque 8 Nm