Replacing the cylinder head (remounting components)
- Release the venting connector (1) at the cylinder head (3) .
- Release the coolant temperature sensor (2)
at the cylinder head (3)
.
- Replace the cylinder head (3)
.
Parts: Cylinder head
- Tighten venting connector (1)
on cylinder head (3)
.TIGHTENING TORQUE SPECIFICATIONS
Venting connector/special tool to cylinder head M10 Tightening torque 18 Nm - Tighten the coolant temperature sensor (2) on the cylinder head (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant temperature sensor at cylinder head | ||
| Sensor | Tightening torque | 18 Nm |