Remounting the camshaft position sensors of the intake camshaft and of the exhaust camshaft
- Loosen screw (1) .
- Unscrew and remove the camshaft position sensor (2) for the intake camshaft.
- Loosen screw (3) .
- Guide the camshaft position sensor (4)
of the exhaust camshaft out and remove.
- Check the sealing ring (1)
for damage, replace it if necessary.
- Thread in and install the camshaft position sensor (2) of the intake camshaft.
- Tighten down screw (1)
.TIGHTENING TORQUE SPECIFICATIONS
Camshaft position sensor to cylinder head cover TS5x20 Tightening torque 4 Nm - Guide the camshaft position sensor (4) of the exhaust camshaft in and install.
- Tighten down screw (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Camshaft position sensor to cylinder head cover | ||
| TS5x20 | Tightening torque | 4 Nm |