Installing coolant feed line for turbocharger

• Check the O-ring (1)  for damage and replace if necessary.
• Coat the O-ring (1)  with coolant.
  CONSUMABLE DESCRIPTION
  
  

  Technically suitable antifreeze and anticorrosion agents

  Courtesy of BMW OF NORTH AMERICA, INC.

• Protect the air duct of the alternator (3)  against contamination using a lint-free rag.
• Position the coolant feed line (2)  at the Y-connector.
• Tighten down screw (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Coolant line from turbocharger to bracket
  M6x30	tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the coolant feed line in area (1)  on the bracket.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the coolant line (1)  .

  The retaining clip must engage audibly. 

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT CENTER .