Removing the fan cowl
Precondition
- Switch off ignition.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING BOTH FRONT-END STRUTS .
- Refer to REMOVING FRONT CROSS CONNECTION (FRONT-END STRUT REMOVED) .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Unlock and loosen the clamps (1).
- Feed out coolant line (2) and place to one side.
- If fitted:
Release the coolant line (1) below at the fan cowl from the clamps and place it to the side.
- Unlock and loosen connector (1).
- Loosen screws (2).
- Guide out fan cowl (3) in direction of arrow and remove.