Replacing the intake plenum

NOTE: RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
Read and comply with user information on using the associated special tool 12 7 060.
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
For additional information see: NOTES ON ESD (ELECTROSTATIC DISCHARGE) PROTECTION .

Loosen clamp (1).
Loosen screw (2).
Remove the boost pressure sensor (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed out the rubber grommet (1) and remove it.
Loosen clamp (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen clamp (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the screws (arrowed).
Remove the throttle bodies (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the sealing ring (1) with the special tool 0 496 714 (00 9 030) .
Parts: Sealing ring

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the throttle body (1).

Tighten the screws (arrowed).

TIGHTENING TORQUE SPECIFICATIONS

Throttle body to intake plenum
6X50	Tightening torque	7 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Check the sealing ring (1) for damage, replace it if necessary.
Parts: Sealing ring
Apply a thin coat of lubricant to the sealing ring (1) of the boost pressure sensor.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the boost pressure sensor (3).

Tighten down screw (2).

TIGHTENING TORQUE SPECIFICATIONS

Boost pressure sensor to intake plenum
TS6X20	Tightening torque	5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.