Installing the intermediate flange of the intake plenum
NOTE:
Description is for left component only.
Procedure on the right side is identical.
Procedure on the right side is identical.
- Replace all sealing rings (1)
.
- Feed in and install the intermediate flange of the intake plenum (2) .
- Tighten all screws in this area (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Vacuum lines to cylinder head M7 | ||
|---|---|---|
| M7 nut | Tightening torque | 15 Nm |
Follow-up work
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT LINE .
- Refer to INSTALLING THE ENGINE VENTILATION LINE ON THE INTAKE SYSTEM .
- Refer to MOUNTING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE LEFT THROTTLE BODY .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to MOUNTING THE RIGHT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE RIGHT THROTTLE BODY .
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE CENTER COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING ACOUSTIC COVER .