Remove brake booster

Preliminary work 

• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
• Refer to REMOVING LEFT AND RIGHT WIPER ARM .
• Refer to REMOVING THE COWL COVER .
• Refer to REMOVING TRAILING LINK AT SPRING BOLT .
• Refer to REMOVING WIPER CONSOLE .
• Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
• Refer to REMOVING TANDEM BRAKE MASTER CYLINDER (PRODUCTION DATE UP TO 10/2015) .
• Refer to REMOVING THE BRAKE LIGHT SWITCH .

• Remove air duct (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen the screws (1) and remove the cover (2).
• Expose brake lines (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove check valve (1) from brake booster in the arrow direction.
• Uncover vacuum line from the holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Retract release tool 2 409 646 between brake pedal and brake booster.
• Put support (1) of the release tool 2 409 646 on the bearing bracket. If necessary position the support fixed by rotating the screw on the release tool.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Press the release tool 2 409 646 in arrow direction and lever out brake pedal from the brake booster.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen nuts (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unscrew the brake booster (1) from the firewall.

Courtesy of BMW OF NORTH AMERICA, INC.