Remove The Outer Section Of The A-Pillar

NOTE: RISK OF DAMAGE 
Carbon Fiber Reinforced Plastic body parts damages. 
Carbon Fiber Reinforced Plastic body parts may not be damaged under any circumstance. 

• Carry out separation cut only on outer component. Do not tap the underlying component.
• While removing the adhesive, do not tap the underlying component.

• (1) Mark severance cut () as pictured and cut. Thereby disconnect only the outer panel.
• Release welded connections in areas (2).
  NOTE: TECHNICAL INFORMATION 
  For additional information see: 41 00... Releasing bonded connections
• Open spot-welded adhesive joints in areas (3).
• Release bonded connection in area (4).
• Release and remove the A-pillar outer part from the cavity sealing (5).

Courtesy of BMW OF NORTH AMERICA, INC.