Installing The Rear Outer Wheel Arch Section
- Clean all bonding surfaces with cleaning agent R1.
- Apply adhesive to bonding surfaces.NOTE: TECHNICAL INFORMATION
When installing the new part, make sure that all bonding surfaces have sufficient adhesive. - Install new part.
- In area (1)
, rivet the new part with blind rivet N3.NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of a cavity sealing (not expanding) - Apply sealant to new cavity acoustic baffle. Install cavity sealing (2) .
Follow-up work
- Refer to ACTIVATE HIGH-VOLTAGE SYSTEM .
- Refer to INSTALL FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .