Installing The Left Luggage Compartment Floor

NOTE: TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment

Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.
CONSUMABLE SPECIFICATION

Cleaning agent R2 500 ml 83190417324
Clean bonding surfaces on vehicle and on new part with cleaning agent R1.
CONSUMABLE SPECIFICATION

Cleaning agent R1 100 ml, Bottle 83192211217
Apply adhesive K5 to the bonding surfaces.
ADHESIVE DESCRIPTION

Body adhesive K5 50 ml 83192158654
Install the new part and rivet it in the area (1) with blind rivets N1.
CONSUMABLE SPECIFICATION

Blind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm 83190301414
In the area (2) , use a bind rivet (N2) .
CONSUMABLE SPECIFICATION

Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm 83190301419

Courtesy of BMW OF NORTH AMERICA, INC.
Weld the new part in the area (3) .
MAG weld the new part in the area (1) . The weld seam has a length of: 10 mm.
Ensure sufficient distance to the bonded rivet connection (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Rivet the new part in the area (2) with blind rivets (N2) .
CONSUMABLE SPECIFICATION

Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm 83190301419
Weld the new part in the area (1) according to the new part preparation process.

Avoid applying too much heat to the adjacent adhesive area (2) .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work