Removing the steering column switch cluster (SZL)
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
TECHNICAL INFORMATION
Wheel alignment is not necessary after removal, installation or replacement.
Wheel alignment is not necessary after removal, installation or replacement.
Preliminary work
- Refer to REMOVING AIRBAG UNIT OF THE STEERING WHEEL OR SPORTS STEERING WHEEL .
- Refer to REMOVING STEERING WHEEL .
- Refer to REMOVING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to REMOVING LOWERING PART OF STEERING COLUMN SHROUD .
- Loosen screws (1).
- Remove the steering column switch cluster (SZL) (2).
- Unlock and disconnect connector (1) on the steering column switch cluster (SZL) (2).