Installing the 12-V lithium-ion auxiliary battery
WARNING:
Working on 12 V electrical system.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Make sure that there is no charger connected to the jump start terminal in the engine compartment.
- Detach battery ground lead from battery.
- For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.
WARNING:
Unprotected battery terminals.
Risk of short circuits! Risk of fire!
Risk of short circuits! Risk of fire!
- Cover the vehicle battery.
TIGHTENING TORQUE SPECIFICATIONS
| Battery cover to battery carrier | ||
| Nut M6 | Tightening torque | 8 Nm |
WARNING:
Incorrect screw connection of the positive battery cable.
Risk of fire!
Risk of fire!
- Ensure that the positive battery cable is screwed with the correct nut.
- Position the positive battery cable (3) on the positive battery terminal.
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to 12-V lithium-ion auxiliary battery | ||
| Nut M8 | Tightening torque | 19 Nm |
- Tighten nuts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to 12-V lithium-ion auxiliary battery | ||
| Nut M8 | Tightening torque | 19 Nm |
- Close the positive terminal cover (1).
- Connect connectors (1) and lock.
Follow-up work
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING THE COMPACT SPARE WHEEL STORAGE TRAY .
- Refer to INSTALLING THE STORAGE TRAY .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to REGISTER BATTERY CHANGE .